Page 1 of 1

DP 4.61 with Powercore

Posted: Wed Dec 21, 2005 4:20 am
by lachr
I'm experiencing crashes with DP and Powercore. During one day I was mixing one song I experienced 7 crashes. It usually happens if I try to change buffer/studio settings, open PoCo plugins or move/copy PoCo plugins to other tracks during playback.

Now, I had all the latest drivers installed, exept the new 1.3 firewire driver for my 828.

Any other DP/Powercore users out there who experinced the same problems?

Best regards

Posted: Wed Dec 21, 2005 10:23 am
by rknaub
With any DSP card, its better to stop the playback if you are changing, moving the plugs to another channel.

I have seen all kinds of problems with the TCPC when tryin to do that.

AS well if you insert a new TCPC plug while DP is playing the automatic delay compensation will not work, until you stop and start the transport again,

Just a few tips.

HTH

Randy

Solution

Posted: Mon Jan 09, 2006 11:31 am
by lachr
Well, it turns out that it probably was the 1.2.5 MOTU 828 driver. After upgrading to 1.3.0 my system seems to run smoth again. Thanks anyway...