Page 1 of 1
Why is the default sampling mode Stretch?
Posted: Sat Nov 17, 2012 6:22 pm
by digaldeman
Whenever I drag a drum sample into MachFive 3, it changes the sample mode to Stretch or sometimes Slice. I want to keep it in regular Sample mode while I preview my drum sounds.
Re: Why is the default sampling mode Stretch?
Posted: Sun Nov 18, 2012 3:06 am
by hugy
Just use the inline browser to preview your samples in that case.
On the left panel, the Tab called Browser.
HTH
Re: Why is the default sampling mode Stretch?
Posted: Thu Apr 18, 2013 6:26 pm
by jduesenb
I'd still like to know, if anyone knows, **why** "Stretch" is the default sampling mode. I don't like this because I'd like to hear my original, unprocessed sample when I first drop it in. "Stretch" can produce a lot of artifacts; it's kind of annoying to have to be changing it back to "Sample" all the time.
thx -- john
Re: Why is the default sampling mode Stretch?
Posted: Fri Apr 19, 2013 2:23 am
by hugy
jduesenb wrote:I'd still like to know, if anyone knows, **why** "Stretch" is the default sampling mode. I don't like this because I'd like to hear my original, unprocessed sample when I first drop it in. "Stretch" can produce a lot of artifacts; it's kind of annoying to have to be changing it back to "Sample" all the time.
thx -- john
Because you have DnD on the Part itself not on the mapping view.
Usually people do this in case of loops not single shot which explains the default behavior