Page 1 of 1
Record enable no sound
Posted: Fri Jun 30, 2006 2:04 pm
by dosuna11
I crashed and had to trash my prefs. Now when I want to monitor a Record enabled track I get no sound. When I disengage the record button I hear the already recorded track. I went to the studio set up monitoring but that did not seem to help. DP 4.6 828mk2 imac G5. I know it is something silly. Please tell me where to look. I can't find it in the manual. PG#?
Posted: Fri Jun 30, 2006 2:17 pm
by Frodo
It sounds like some very basic bus settings need a peek.
What are you recording?
--- VI's to audio?
--- Acoustic instruments or vocals via external mic?
Are you bouncing to disk?
Posted: Fri Jun 30, 2006 2:34 pm
by MattC
Sounds from your post like you probably already checked this, but "Audio Patch-Through" enabled? Or if going the zero-latency route, CueMix channel unmuted?
All the best!
Matt
Posted: Fri Jun 30, 2006 5:46 pm
by dosuna11
Thanks! Audio Patch thru. I went to teach and came back. I had checked it but no avail. Now 3hrs later it works. Computers!!!