Low mic input only in Cuemix

Moderator: James Steele

Forum rules
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. with Windows
Post Reply
mannybiker
Posts: 8
Joined: Mon Feb 22, 2010 2:20 pm
Primary DAW OS: Unspecified

Low mic input only in Cuemix

Post by mannybiker »

I have a strange problem. I use a Shure SM58 connected via a balanced XLR cable on the back of my Ultralite MkIII and trimmed at 28db. I want to direct monitoring my voice so I have unmuted Mic2 in the Mix tab of Cuemix. The Input fader of Mic2 is at the maximum level as well as the Bus Output fader. I can record the voice on my DAW without any problem and I can see that on the input meter of the DAW the signal is good (4db) but when I check the input level meter of the Cuemix it never go over the 48db line. I would like to better monitor my voice because it is pretty low but it is ok when it is recorded on the DAW.

Any suggestion? :banghead:
Many thanks!
Top
4stripes
Posts: 259
Joined: Mon May 07, 2012 7:44 pm
Primary DAW OS: Windows

Re: Low mic input only in Cuemix

Post by 4stripes »

Do a factory reset and start over with levels. It's in the manual how to do it.
Top
Post Reply

Return to “MOTU Hardware & Windows”