Hi,
I just started using an m-audio Project Mix I/O
as a firewire-based control surface with Digital Performer.
I'm liking it a lot but have a couple of question/concerns.
The plugin button (on the PMIO) only lets me change which plugin
is in a selected slot in DP but control their knobs/parameters etc.
Would this be typical of most control surfaces or is
it just the PMIO?
Also, I can only see the tracks in the software mixer that correspond
to the bank of 8 that is selected by the PMIO. I can understand this but personally would like to see all the tracks that can fit on my two monitors but be able to switch between banks of 8 for fader control
etc...
Is this configurable in DP or this typical for 8-fader
Control Surfaces?
Thanks,
Jon
Do both of these features/complaints exist in PT as well? I can live
with them but I'm just curious.
Thanks,
Control Surface with DP questions
Moderator: James Steele
Forum rules
This forum is for most discussion related to the use and optimization of Digital Performer [MacOS] and plug-ins as well as tips and techniques. It is NOT for troubleshooting technical issues, complaints, feature requests, or "Comparative DAW 101."
This forum is for most discussion related to the use and optimization of Digital Performer [MacOS] and plug-ins as well as tips and techniques. It is NOT for troubleshooting technical issues, complaints, feature requests, or "Comparative DAW 101."