S/PDIF as Send / Return on 828 mk3?

Moderator: James Steele

Forum rules
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. for Mac OSX
Post Reply
ioplex
Posts: 9
Joined: Fri Aug 20, 2010 3:08 pm
Primary DAW OS: Unspecified

S/PDIF as Send / Return on 828 mk3?

Post by ioplex »

Is there any way to use the S/PDIF on the 828 mk3 as a send / return to insert a reverb unit?
NazRat
Posts: 1214
Joined: Sat Feb 07, 2009 1:55 pm
Primary DAW OS: Unspecified

Re: S/PDIF as Send / Return on 828 mk3?

Post by NazRat »

With a DAW, assign the send to the 828mk3 S/PDIF output and for the return create an Aux (or audio) track with the 838mk3 S/PDIF input as the input to the Aux (or audio) track. If you're doing this with CueMix FX in a live mixer scenario, you'll need to setup a mix buss with S/PDIF as the output - that will be the send side. The return will be the S/PDIF input in the mains mix buss (usually buss 1). Clock your reverb unit to S/PDIF to avoid any sync issues. All assuming that the verb has digital I/O.
DP8.06 PT11.2.0 VEP 5.3.x
828mkII 828mk3 ADA8000 MTP-AV Komplete Audio 6
Mac Mini Quad 10.9.4 - HP Quad Laptop Win 8.1
ioplex
Posts: 9
Joined: Fri Aug 20, 2010 3:08 pm
Primary DAW OS: Unspecified

Re: S/PDIF as Send / Return on 828 mk3?

Post by ioplex »

Of course 5 minutes after I posted I found the solution - use a separate bus. I used Bus 2 for all inputs that will get the outboard effect and set it's primary output to S/PDIF 1-2. Then on Bus 1 the S/PDIF input is the return and I can mix that in as desired.

Mike
Post Reply