REAKTOR not showing Up (EDIT)

artmusicsouth · Post by **artmusicsouth** » Thu May 10, 2007 7:30 am

I installed Reaktor the other day but it is not showing up in DP Anythoughts here?

Mark

jarok · Post by **jarok** » Thu May 10, 2007 7:48 am

Reason works with ReWire connection with DP.
Start DP first create AUX track, Audio track and MIDI track.
Assign those tracks to Reason.
Start Reason.
Read the chapter 72 ReWire in DP5 manual.

If you have Intel Mac make sure that you have Reason3.0.5.

jarok

artmusicsouth · Post by **artmusicsouth** » Thu May 10, 2007 7:55 am

I goofed here. I meant to say Reaktor.

I can't even get DP to see Reaktor. When I try to assign it it does not show up. Did I miss something on the install with Reaktor? I have v5.1.2 by the way.

jarok · Post by **jarok** » Thu May 10, 2007 8:30 am

Ok.

Repair permissions with Disk Utility.
If you have AU version of Reaktor.
Trash your Audio Unit Info Cache so DP will analyze
all AU components again.

Hope this helps.

jarok

artmusicsouth · Post by **artmusicsouth** » Thu May 10, 2007 10:57 am

I am getting nothing. DP never ran the set-up like it did when I first installed it.

Mark

aizo · Post by **aizo** » Thu May 10, 2007 8:51 pm

i had the same thing happen when i installed komplete 4 on my macbook. jus reinstall reaktor. or....go the service center and make sure you have the latest version downloaded. it showed under native instruments: reaktor...then showed up after i turned off dp and restarted it in the native instruments folder. other than that...i dont knows mein