8 ch's of analog->ADAT->analog w/828?

[jstaczek]

It seems like it ought to be possible to route the 828's 8 analog ins to ADAT 1-8 out, and then route ADAT 1-8 in to 1-8 analog out. But after futzing with CueMix for a while, it's either impossible, or I can't figure it out. Best I can get is four in/four out, like this:

Mix 1: analog 1 2 panned L R, output = ADAT 1-2
Mix 2: analog 3 4 panned L R, output = ADAT 3-4
Mix 3: ADAT 1 2 panned L R, output = Analog 1-2
Mix 4: ADAT 3 4 panned L R, output = Analog 3-4

Am I missing something? Anyway to route an input directly to an output?

Thanks,

[gameu]

You can create 2 different mix presets and swap between them:

Mix 1:
Bus 1: analog in 1-2 to Adat out 1-2
Bus 2: analog in 3-4 to Adat out 3-4
Bus 3: analog in 5-6 to Adat out 5-6
Bus 4: analog in 7-8 to Adat out 7-8

Mix 2:
Bus 1: Adat in 1-2 to analog out 1-2
Bus 2: Adat in 3-4 to analog out 3-4
Bus 3: Adat in 5-6 to analog out 5-6
Bus 4: Adat in 7-8 to analog out 7-8

but you won't get both at the same time, unlesss you make your routing in your audio sequencer.