MOTUnation.com

The 8pre doesn't have a button combo that you have to hold to boot it into the firmware update mode. The firmware update program sends a message to the interface that puts it in the update mode. If the update program isn't detecting the interface, it might be because you haven't installed the lates...

Hi all, I'm sorry if this is obvious, I've done some searching without any luck here. Maybe I missed it. I'm trying to update my 8pre for my Windows XP system. Every time I run the updater it says "There are no devices in update state. Please turn on the device." It is of course on, but no...

Ok, well I went out and bought a Radeon based card and it seemed to work fine when I first hooked it up...after I installed the latest Radeon drivers the exact same problem resurfaced. I updated the BIOS to the latest version and made sure every single driver was updated. I also tried alternating th...

See my post just a couple down.

My problem was my nvidia geforce card and drivers.

If you have onboard video or another non-nvidia card try using that and uninstalling the nvidia drivers. It fixed my problems.

Ya, I have an onboard one too. It's a Geforce 8500 card I believe. I actually found one other forum where this was mentioned and they said it started with the newest nvidia drivers back in June. I have a new system with a clean install of Vista so there are no old drivers lurking around... I also ha...

So after literally trying EVERYTHING under the sun to get my 8pre working. I finally started pulling components. I discovered that when my nvidia geforce card is not in the system and the drivers are uninstalled the unit works perfect. I have a Windows vista system with 4gig RAM. With my graphics ca...