MOTUnation.com

Thanks Mike A total reboot helps the issue as well. I did that first. Simply quitting DP and reopening does the trick too. First time I ever experienced that type of issue, It's weird. Should get time machine up and running as well. I have a feeling I have some kind of solo/ monitoring, or other but...

Recently upgraded to DP 10.11, new MOTU 828 ES interface, on a new 27” IMac Was working on preserving some old cassette tapes (in real time) of my former band digitally. Stereo L & R out of cassette deck into 828 mic/line 1&2. Simple enough. After recording and editing 5 or 6 tunes, I bounce...

I'm not much of a keyboard player,I just use it to trigger drums and other instruments when I don't have access to use all of my musician friends for recording. I got the trusty old manual out, and I had to select and page through some banks, til I got to the general MIDI window which was turned off...

It turned out to be a problem with the QS6 keyboard settings, General MIDI was turned off by mistake somehow. I'm back to MIDI madness again, until the next crisis.
Thanks again for all your help !

I'm thinking I may have a MIDI feedback issue somewhere as well, but no eerie feedback sounds are heard which you typically hear when there's a loop going on though. Plays back normally too. When I shut down, rebooted, reconnected input and output points, etc., then opened up (any) project and teste...

Using an IMac 10.6.8/DP 6.03 It's been a while since I've recorded and edited MIDI data within DP. (Using 6.03 should be a giveaway) It was working fine and I was getting myself use to editing MIDI data within the event list again. Opened a new project and all of a sudden I'm getting massive amounts...

Still baffled by this problem. Can't understand why all the playback outputs are not playing thru the assigned channels on my mixing board. Motu 828-1 outputs are playing back thru channels 17-24 on the mixer (even though they are wired to play thru channels 1-8) Motu 828-2 outputs are playing thru ...

Thanks I'll try that. Would like to know if anyone has experienced this using 3 828's via firewire hub. Take one 828 out of the chain and it's fine. Checked all the hub inputs too, all working good.

I am using 3 (original) 828 interfaces in my rig thru a firewire hub. (Just added the third one). Before the additional 828, I had no problem with input and output assignments when fed to my 3204 Mackie board. The first 828 played back thru channels 1-8, the second 828 played back thru channels 9-16...

Hi - Not sure if this is the right forum, but I'll give it a shot. I would like to know if anyone has successfully used this configuration (or close to it) without any problems. I plan on using a firewire hard drive for storage of my music files. Does the Imac G5 have enough gas to lay out say 20 tr...