Page 1 of 1

Is there a way to grab the off velocities in the MIDI editor

Posted: Sun Nov 06, 2005 12:46 pm
by Hesseman
In the MIDI editor, how does one grab the off velocity hits?? Or can you?? My hand tool only seems to grab the on hits...
Thanks

Posted: Thu Nov 10, 2005 10:31 am
by yofo
I think you can go to the graphic editor and switch the view filter to "off velocities" and then highlight them and then switch back to MIDI editor and then grab them. I hope thats right !

Off Velocities in graphic editor

Posted: Thu Nov 10, 2005 8:30 pm
by ClydeXP
HI,

I ran into this one also.

I have an old version of DP (3.11) and in that one you can't grab the off velocities in the graphic editor. Instead you have to go under the Change Velocty command in the Region menu and you can select off veloctites instead on on velocities. So you'd make your selection of notes, go there and change the value for the off velocities.

According to the manual, you can see the off velocities in the graphic editor but that's about it.

I don't know if this helps, but it works in DP 3.11

Posted: Thu Nov 10, 2005 8:45 pm
by chrispick
I'm pretty sure you can just grab them -- only they're hard to grab. If I remember correctly, I've adjusted them before by simply moving them.

Posted: Fri Nov 11, 2005 12:46 am
by blue
You can't grab them, but you can edit them in the event list and in the event strip on the graphic editor. Select the notes first, then pop edit the numbers.