Request for Tips: switching from 48-96 (a newbie moment)
Posted: Sat Nov 05, 2005 3:00 pm
Hi everyone,
Since I haven't found anything so far specifically addresing this question, i'll post: does anyone have specific tips on how to switch a project from 48 to 96 mid stream.
I have done a lot of MIDI programming and all the analog tracks are placeholder, so i do not mind "losing" them as they need to be re-recorded.
I know the basic step of set up in DP. But when I tried to do it on one particular file, I got something of a hiccup loading one of my plug ins which was claiming something to the tune of that there wasn't enough space (or possible allocation of space) for the higher resolution samples. So I think i could use some guidance on what to look out for and be sure to do when making this transition.
My basic set up follows below. Any tips/guidelines are much appreciated. Thanks!
Orange
Since I haven't found anything so far specifically addresing this question, i'll post: does anyone have specific tips on how to switch a project from 48 to 96 mid stream.
I have done a lot of MIDI programming and all the analog tracks are placeholder, so i do not mind "losing" them as they need to be re-recorded.
I know the basic step of set up in DP. But when I tried to do it on one particular file, I got something of a hiccup loading one of my plug ins which was claiming something to the tune of that there wasn't enough space (or possible allocation of space) for the higher resolution samples. So I think i could use some guidance on what to look out for and be sure to do when making this transition.
My basic set up follows below. Any tips/guidelines are much appreciated. Thanks!
Orange