MOTUnation.com

I just installed MSI and was quite excited to dive into it and see what I could do with it but then noticed a strange MIDI problem. When I load a multi that has more than one instrument assigned to the same MIDI channel no MIDI data gets through to that particular channel but will still get through to the others. The led's will light up for the other channels but not for that one. It works fine as long as all the parts are on different channels.

Has anyone else noticed this or does anyone have any solutions?

Of note...if I create my own multi with multiple parts assigned the same MIDI channel it works fine when loaded.

I am using DP 4.6 on a Dual 2.5 OS 10.4.2

Thanks.

Hi,

This multi should use keyswitch.
Check the expert mode window to see the key which are used to activate each part.

I think the keyswitch is explained in the additonal paper.

Hope this helps.