Page 1 of 1
Click is not in sync ..........
Posted: Tue Jan 20, 2015 9:57 am
by tablehead
For some reason this just started happening. It's about a 32nd note off.......I've trashed prefs, reset my 828Mk3, rebooted everything countless times and still no luck. It's only happening on new projects. I've searched this thread and the manual........no luck. Any ideas would be most appreciated!
Re: Click is not in sync ..........
Posted: Fri Jan 23, 2015 8:33 am
by HCMarkus
tablehead wrote:For some reason this just started happening. It's about a 32nd note off.......I've trashed prefs, reset my 828Mk3, rebooted everything countless times and still no luck. It's only happening on new projects. I've searched this thread and the manual........no luck. Any ideas would be most appreciated!
Look-ahead limiters on Master Buss will mess up click timing.
Re: Click is not in sync ..........
Posted: Tue Jan 27, 2015 8:24 pm
by tablehead
Ok.........it is the UAD Precision limiter, but only does it on certain new projects. Thanks for your help!!
Re: Click is not in sync ..........
Posted: Tue Jan 27, 2015 9:46 pm
by HCMarkus
tablehead wrote:Ok.........it is the UAD Precision limiter, but only does it on certain new projects. Thanks for your help!!
You are very welcome.
Re: Click is not in sync ..........
Posted: Tue Jan 27, 2015 10:22 pm
by dosuna11
Does this have to do with run in real time?
Re: Click is not in sync ..........
Posted: Thu Jan 29, 2015 2:45 pm
by tablehead
I confess I don't know if I'm "running in real time". I rarely change any preferences, so I am pretty confused why this just started on just a few projects..........I will look into that.
Re: Click is not in sync ..........
Posted: Thu Jan 29, 2015 10:00 pm
by dosuna11
Running in real time is in an arrow drop down menu in the upper right hand corner of the opened plug-in window. It sure messes with my time in my MIDI sequences.