getting a MachFive 3 output into a aux bus
Posted: Wed Sep 12, 2012 8:47 am
This is about MachFive 3 running in DP 7. I'm missing some fundamental concept in the interface.
I want to take a single part and patch it into an external bus so I can apply my DP plugins to that part (and only that part) while I run the rest of the MachFive parts to a separate V-rack bus. I cannot figure out how to do this. I have no trouble routing that entire MachFive instance, but I don't understand how to break a single part out of MachFive and get it into DP. I don't think I need the internal MachFive busses to do this; am I wrong?
I don't understand where the part ouputs (within the main window under each part, the list that says Main Out, Out 2, Out 3, etc) are going. Why can't I route them to DP's bus list? Where do these outputs show up in DP? How do I access these part outputs in DP? I used to do this in MachFive 2, but they changed the part outputs in this latest version.
I need a step-by-step method on how to do this. I can't believe something so basic isn't explained, which leads me to believe I'm misunderstanding how Mach5 and DP communicate.
thanks to anyone who can help!
I want to take a single part and patch it into an external bus so I can apply my DP plugins to that part (and only that part) while I run the rest of the MachFive parts to a separate V-rack bus. I cannot figure out how to do this. I have no trouble routing that entire MachFive instance, but I don't understand how to break a single part out of MachFive and get it into DP. I don't think I need the internal MachFive busses to do this; am I wrong?
I don't understand where the part ouputs (within the main window under each part, the list that says Main Out, Out 2, Out 3, etc) are going. Why can't I route them to DP's bus list? Where do these outputs show up in DP? How do I access these part outputs in DP? I used to do this in MachFive 2, but they changed the part outputs in this latest version.
I need a step-by-step method on how to do this. I can't believe something so basic isn't explained, which leads me to believe I'm misunderstanding how Mach5 and DP communicate.
thanks to anyone who can help!