Macro Controls Values
Posted: Sat Aug 25, 2012 12:26 pm
Is there a way to set a specific range for a macro control knob? E.g. if using a filter cutoff and map it to a macro would it be possible to set the filter range from 2khz - 4khz. In addition,
it would be an improvement to read the exact filter values in the macro knob when turning it instead of percentage values. This would be great so i don`t have to switch between info view and edit view when fine tuning the macro values.
Can i re-order the macro knobs in the tree editor?
Thanks,
Oliver
it would be an improvement to read the exact filter values in the macro knob when turning it instead of percentage values. This would be great so i don`t have to switch between info view and edit view when fine tuning the macro values.
Can i re-order the macro knobs in the tree editor?
Thanks,
Oliver