MOTUnation.com

HELP??!?!?!?!?

I recently bought an 8pre to use with Cakewalk PE 8.5. I can't get anything to work so I'll start with my first question.

The system and Cakewalk both recognize that the 8pre is installed.

When I open CueMix and adjust anything, within a couple of seconds it resets itself to where it was.

I have always been good with computers, but I have about 20 hours into this setup and I'm ready to throw something through the wall!!!

I'm using Windows 7 64 bit. The 8pre is running through a FW PCI card wit TI drivers.

Any help would be greatly appreciated!!!

I had it working and was thrilled.

Then I had to reboot and now it doesn't work again.

What am I missing?

I don't have the 8pre, but in Sonar which audio drivers are you selecting? Which one's are active in Cue Mix?

I'm using the ASIO drivers.

I have no way to tell what driver CueMix is set to use.

Hey, just wondering if you found a solution to this problem, I seem to have it as well...
Thanks!

Bit of an old thread resurrect? I've seen this trick help out FireWire devices in general (including audio interfaces). Maybe worth shot? I would turn off any FW gear before attempting the swap.

Check out the vid (way easier than explanation):

http://www.youtube.com/watch?v=s4JfbDW6AtI" onclick="window.open(this.href);return false;