Factory Reset on 828 MKII
Posted: Tue Mar 31, 2009 3:27 pm
Hi all,
I needed some help in finding a solution to a problem with my analog outs. It appears when i connect an instrument on 1/2 or 3/4, 5/6/ and 7/8 everything shows up fine in the cue mix. However! Once i load up logic or Ableton the inputs are not audible on those exact inputs. Example - I connect a Synth to Analog input 1/2, once I open Ableton 7 or logic Pro 8 to record from the 1/2 input i get no audio, but if i change the input to 3/4 the signal comes through! I'm totally lost as to why this is. So basically every analog input is only audible in my recording software one stereo group over. This is wacky. If anyone knows this or how to do a factory reset since i lost my manual that would be great. Thanks!
I needed some help in finding a solution to a problem with my analog outs. It appears when i connect an instrument on 1/2 or 3/4, 5/6/ and 7/8 everything shows up fine in the cue mix. However! Once i load up logic or Ableton the inputs are not audible on those exact inputs. Example - I connect a Synth to Analog input 1/2, once I open Ableton 7 or logic Pro 8 to record from the 1/2 input i get no audio, but if i change the input to 3/4 the signal comes through! I'm totally lost as to why this is. So basically every analog input is only audible in my recording software one stereo group over. This is wacky. If anyone knows this or how to do a factory reset since i lost my manual that would be great. Thanks!