Creating subgroups on 896mk3 / CueMix FX
Posted: Mon Jul 14, 2008 4:59 pm
Just route thru AES and / or SPDif out, then loop back in with a cable, and route out to main, don't use these source channels into main too...
There is some additional delay but not much...
Take care
Klaus
( BTW, the 896mk3 is working nicely with AULab as a live mixer, 128 buffer,
gives about 3 meter in the air, measured with Smaart )
There is some additional delay but not much...
Take care
Klaus
( BTW, the 896mk3 is working nicely with AULab as a live mixer, 128 buffer,
gives about 3 meter in the air, measured with Smaart )