Page 1 of 1
828 bit settings
Posted: Mon May 19, 2008 6:58 pm
by retzin
I am using Reaper with an 828 interface.
It is set up at 32 bits.
I would like to change this, but cannot figure out how to do it.
Any thoughts?
Posted: Sun May 25, 2008 5:48 am
by ngarjuna
I'm in the same boat here, Reaper with an 828mkIII. I'm not unhappy with 32bit necessarily (I was trying to set it to 24 bit which is what I'm used to using), but I would like for the unit to work properly at whichever bit rate I want just in case I ever have a reason to not want to use 32 bit.
Posted: Mon Jun 30, 2008 12:46 pm
by m687bc
I.ve just install an 828mk1 for Reaper as well. I can not get proper operation under 512 spls. Any suggestions? Would like to run the 828 at a lower setting.
Would surely appreciate any assistance.