Page 1 of 1

Waves plugins stop sounding

Posted: Tue Oct 09, 2007 2:22 pm
by AriWinters
HELP!!
I think I remember reading about this somewhere once before, but I cannot for the life of me remember where. My waves plugins (as insert effects in Digital Performer 5.12, on a Mac PPC OSX 10.4.9, with 2.5 gb of ram), will stop sounding at the end of the audio clip in the sequence track. Is there a preference somewhere that geeked? It's very strange that it is only the waves plugins. Everything else will carry out well passed the audio clip. Please advise! Thanks.
-Ari

Posted: Thu Oct 11, 2007 7:02 am
by Tritonemusic
That's just the way it is when using the AU versions. In fact, that's the only reason I still use Waves MAS. I can't stand hearing the reverb cut out so abruptly.
I know that a lot of people have problems with the MAS versions but I don't. Give it a try if you haven't already.

None of this really matters since you know Waves will come out with a new release in a matter of minutes! :roll:

Posted: Thu Oct 11, 2007 7:13 am
by stephentayler
Does it help if you set the plugins to 'Always Run In Real Time'?

cheers

Stephen