Page 1 of 1
Convert Analog to ADAT with 2408 in StandAlone... How???
Posted: Fri May 11, 2007 7:22 pm
by abcdefg
Hi!
I think that we can use the 2408 as a simple converter in stand alone mode...
How can I convert the 8 analog in to 8 ADAT out?
It's a 2408 mkIII.
Thanks!
Posted: Fri May 11, 2007 8:03 pm
by jrdmcdnld
I've done this with my 828mkII and an ADAT LX20. I used cuemix to route the analog ins to adat outs. You can probably do a similar thing with your 2408.
Posted: Fri May 11, 2007 9:38 pm
by abcdefg
Hi!
Thanks!
But if my goal is to use the 2408 WITHOUT a computer?
Use it as a simple Converter?
Is it possible to achieve this in stand alone mode without the software?
Thanks!
Posted: Sat May 12, 2007 4:13 am
by jrdmcdnld
The 828mkII remembers the cuemix settings after disconnect - don't know about the 2408. I set it up with a computer, but then I disconnected it and took it on the road with the adat. it worked great.
Posted: Sat May 12, 2007 5:28 am
by abcdefg
Thanks!
I'll try that...
And if anyone knows a specific way with the 2408, without the software, directly on the unit, let me know!
Posted: Sat May 12, 2007 12:49 pm
by jrdmcdnld
according to this....
http://www.motu.com/techsupport/technot ... standalone
...standalone operation is in your manual.