Driver 3.6.8.1

medusa · Post by **medusa** » Mon Jun 30, 2008 1:37 pm

Is there anybody who knows what is new in this update?

trunk79 · Post by **trunk79** » Mon Jun 30, 2008 5:36 pm

i the greatest new addition in that i get a cyclic redundancy check error and cant update my motu828mk3, fantastic, what will they think of next, not to mention they dont seem to let me registor the product i bought because someone apparently has that serial number already, i hate my mk3 cant recommend anything good about it shoulda bought a focusrite or stuck with my mackie, worst customer support ever

RonaldS · Post by **RonaldS** » Tue Jul 01, 2008 11:16 am

DueMixDSP has been replaced with a tool called CueMix FX...looks more "modern" now.

Install worked good on the second try. First I tried to update the drivers whilst my 828MKII was attached --> BlueScreen.
Second try: Update with Motu turned off--> Everything fine.

best regards

mills · Post by **mills** » Tue Jul 01, 2008 4:20 pm

More latency
Less options

WTF MOTU

CSprague · Post by **CSprague** » Tue Jul 01, 2008 7:39 pm

Just loaded it on my DAW (in-progress), stripped out the old version, loaded the new with my 828mk3 turned off. No problems noted on playback, have not played with the recording yet. The Cuemix FX is lacking, but I'm new to it, I'm use to E-MU 1820m Patchmix that had far more control over redirects and individual channel effects. I noticed a few things greyed out, but again I'm new. I found the channel slider control an mains restrictive at 0dB. If my input is weak it doesn't give me much headroom to compensate. Again no hardware issues yet, I'm using the FW buss on my motherboard that used the TI chip. After I get my Sonar Producer 7 loaded I'll be better able to judge it recording capability.