MachFive 2 Standalone Clicks/Pops into DP

[malditoyanki]

Hi gang,

I used to run MachFive 2 out of the lightpipe on the back of my Mac into my interface, but clocking was sketchy that way.

I got a Apogee Symphony card and am trying to now route the sound out of Symphony's Vbus into DP. It works but.......the clocking is horrible. Click and pops galore.

I have a Big Ben master clocking my Rosetta. Rosetta is connected to Symphony PCI.

[bjornln]

Hi gang,

I used to run MachFive 2 out of the lightpipe on the back of my Mac into my interface, but clocking was sketchy that way.

I got a Apogee Symphony card and am trying to now route the sound out of Symphony's Vbus into DP. It works but.......the clocking is horrible. Click and pops galore.

I have a Big Ben master clocking my Rosetta. Rosetta is connected to Symphony PCI.

Try if increased buffers help...


/B

[malditoyanki]

Get this!

LOWERING the buffers in DP to 128 cleaned up the sound! However, I can't run a sequence at 128 with other plugins running without getting overload messages every 2 seconds.

Crap...

[malditoyanki]

Here's the answer.

Set buffer to 128 THEN change host buffer multiplier to 3.

sound is clean and I detect no latency when I perform.