MOTUnation.com

Understandable. I figure the cr1604 although older, would still hold up to the Mackie name in sound quality. Basically, it would just be easier to eq with the analog board then having to go back after the signal lines were recorded. I'm more so questioning the proper way to channel everything. I'm j...

I plugged my 8 pre into a Mackie cr1604 via 1/4inch all 8 channels?
I'm hoping I could route it someway to headphones and a more "analog" mixer feel.

-Sam

I'm running 1/4 direct from my line 6 head to my 8pre. -20db on I'm getting slight feedback and major clipping on playback through Sonar 7. The tone sounds much weaker than if played through the cab. Meanwhile the levels seem to be fine. Barely in the red zone. I'm trying to get a louder cleaner sig...

update: the head is being used so that the effects will process (eq,distortion, levels) going (direct out/phones) 1/4inch to ch 8 8pre. the motu main outs (1/4 inch) i figured served to monitor, so i directed them to the 4x12 (just a speaker cab) i realized, the cab has no power so is receiving a lo...

I have my 8pre firewired to Sonar 7 and the main outs connected to my 4x12 via 1/4 guitar cables. I have my guitar head 1/4 inched to ch 8 of my 8 pre. I get a very low monitor signal, while getting a strong guitar signal. Sonar 7 main out is motu main outs (Right, Left) My question is, how do I mak...