When I power if off of the AC power it goes
Initializing Setup Data
Initializing .... Mix
v1.07
and then it starts normally.
If i connect the firewire cable, though, it freezes or just doesn't work.
And how do I know I have reseted it to factory settings?
Thank you guys
Search found 3 matches
- Sun Mar 16, 2008 10:18 am
- Forum: MOTU Hardware & MacOS
- Topic: Initializing Setup Data
- Replies: 5
- Views: 1158
- Fri Mar 14, 2008 4:52 pm
- Forum: MOTU Hardware & MacOS
- Topic: Initializing Setup Data
- Replies: 5
- Views: 1158
Thank you guys! Well, following these last steps the interface is not freezing. It boots up, shows the v1.07 firmware version and starts normally. After the resetting steps it still shows the v1.07 firmware but initiates normally, but if after initiated I plug in the firewire cable, it freezes. Did ...
- Tue Mar 11, 2008 9:04 pm
- Forum: MOTU Hardware & MacOS
- Topic: Initializing Setup Data
- Replies: 5
- Views: 1158
Initializing Setup Data
Well! I had my traveler to work fine till today when I turned it in(actually tried) and it didn't work through the firewire power option. Then I thought I would have to reset everything, so I did it. Reset the software and driver installation, but it seemed not to work... Out of nowhere, again, It s...