I have two MIDI Express XT units, and they are both connected to my Mac Studio via a powered hub. When I first set them up, Clockworks was able to handle both devices at the same time. However, at some point this stopped working (I haven't really changed much in the mean time, for example I haven't done a major MacOS upgrade or anything like that - the studio is a recent build). As of now, I can power on a single MEXT unit (either one) and it appears in Clockworks... but it they're both on, then only one appears: the other one isn't shown.
I thought I should ask here in case I've done something stupid! Perhaps someone else has already fixed this issue and can help?
Many thanks!
Clockworks on a Mac Studio can no longer recognise TWO MEXTs?
Moderator: James Steele
Forum rules
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. for Mac OSX
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. for Mac OSX
Re: Clockworks on a Mac Studio can no longer recognise TWO MEXTs?
I would try looking in Audio MIDI setup and make sure both units are hooked up there. You might have to add one.
Used 2012 Mac Pro 3.33 6 Core 16g ram 10.8.5 DP 7.24
- James Steele
- Site Administrator
- Posts: 21249
- Joined: Fri Oct 15, 2004 10:01 pm
- Primary DAW OS: MacOS
- Location: San Diego, CA - U.S.A.
- Contact:
Clockworks on a Mac Studio can no longer recognise TWO MEXTs?
I wonder if your two interfaces would just appear as one 16 in and 16 out interface. That’s what used to happen when I would daisy chain my old MTP off my MTP/AV USB.
JamesSteeleProject.com | Facebook | Instagram | Twitter
Mac Studio M1 Max, 64GB/2TB, MacOS 14.5 Public Beta, DP 11.31, MOTU 828es, MOTU 24Ai, MOTU MIDI Express XT, UAD-2 TB3 Satellite OCTO, Console 1 Mk2, Avid S3, NI Komplete Kontrol S88 Mk2, Red Type B, Millennia HV-3C, Warm Audio WA-2A, AudioScape 76F, Dean guitars, Marshall amps, etc., etc.!
Mac Studio M1 Max, 64GB/2TB, MacOS 14.5 Public Beta, DP 11.31, MOTU 828es, MOTU 24Ai, MOTU MIDI Express XT, UAD-2 TB3 Satellite OCTO, Console 1 Mk2, Avid S3, NI Komplete Kontrol S88 Mk2, Red Type B, Millennia HV-3C, Warm Audio WA-2A, AudioScape 76F, Dean guitars, Marshall amps, etc., etc.!
Re: Clockworks on a Mac Studio can no longer recognise TWO MEXTs?
Thanks! l believe both units show in there, but one is disabled and can't be accessed. So the system knows about its existence, but can't talk to it.
Re: Clockworks on a Mac Studio can no longer recognise TWO MEXTs?
That's an interesting phenomenon! I'll definitely check again in case this has happened, but I think I would probably have noticed. My two units, by the way, are plugged into USB on separate ports of the hub, so I wouldn't say they were daisy chained. Not sure whether that makes a difference or not...James Steele wrote: ↑Sun Jun 04, 2023 3:17 pm I wonder if your two interfaces would just appear as one 16 in and 16 out interface. That’s what used to happen when I would daisy chain my old MTP off my MTP/AV USB.