Stopping automation snap to grid
Posted: Sun Feb 11, 2018 1:47 pm
Hi,
I'm trying to perform a simple volume automation on an audio track. I've spent a good hour watching videos, researching the manual, and doing searches and have finally found how to create the automation track and add nodes to it. The issue I'm having now is that the nodes are snapping to some sort of grid so I can't place them where I want.
I would appreciate any help on figuring out how to turn this off.
Also, is there a better resource for information on DP than the manual and youtubes? If every little task takes this long to uncover the basic information I'm going to have a hard time making progress.
Your help would very much be appreciated. I apologize if I'm sounding snarky, I'm just a little frustrated at the moment.
Thanks!
I'm trying to perform a simple volume automation on an audio track. I've spent a good hour watching videos, researching the manual, and doing searches and have finally found how to create the automation track and add nodes to it. The issue I'm having now is that the nodes are snapping to some sort of grid so I can't place them where I want.
I would appreciate any help on figuring out how to turn this off.
Also, is there a better resource for information on DP than the manual and youtubes? If every little task takes this long to uncover the basic information I'm going to have a hard time making progress.
Your help would very much be appreciated. I apologize if I'm sounding snarky, I'm just a little frustrated at the moment.
Thanks!