routing configuration
Posted: Fri Mar 27, 2015 10:09 am
Hi, just bought an 828mk3 firewire and although I've read the manual and watched the videos I'm still having a little trouble so big apologies if I'm being an idiot.
My problem is this:
I'm using a pair of Apogee rosetta 800's in stand alone mode as my main 16 channel i/o, and the 828 mainly as a way of getting the Apogee audio in and out of the mac via the ADATs, but the extra i/o may be used occasionally.
Channel 1 on my analogue desk is hard wired to channel 1 on the apogee, which comes up as ADAT A1 on the 828 which shows up in Logic Pro X as input 17. My previous audio interface allowed me to route ADAT A1 to show up as input 1 in Logic, is there a way of doing this with the MOTU......?
My problem is this:
I'm using a pair of Apogee rosetta 800's in stand alone mode as my main 16 channel i/o, and the 828 mainly as a way of getting the Apogee audio in and out of the mac via the ADATs, but the extra i/o may be used occasionally.
Channel 1 on my analogue desk is hard wired to channel 1 on the apogee, which comes up as ADAT A1 on the 828 which shows up in Logic Pro X as input 17. My previous audio interface allowed me to route ADAT A1 to show up as input 1 in Logic, is there a way of doing this with the MOTU......?