I have a motu 24i and 2408mkII with a PCI 324 card. I'm wondering if there is a way to adjust the operating levels of the convertor boxes. I just tracked some drums with the pres padded down and found that my levels were so hot going into the convertor I had to use a limiter on them to keep from clipping.
Any suggestions?
Convertor Operating Level
Moderator: James Steele
Forum rules
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. for Mac OSX
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. for Mac OSX
-
guy_who_invented_fire
- Posts: 1
- Joined: Tue Feb 20, 2007 12:16 pm
- Primary DAW OS: Unspecified
-
monkey man
- Posts: 13936
- Joined: Fri Apr 22, 2005 10:01 pm
- Primary DAW OS: MacOS
- Location: Melbourne, Australia
Hey, guy_who_invented_fire, Welcome to UnicorNation!
You might want to check the internal jumper settings in the MkII unit.
If they're in the "-10" position, it's a no-brainer; flick 'em to "+4".
Again, welcome, and have fun!
MM
You might want to check the internal jumper settings in the MkII unit.
If they're in the "-10" position, it's a no-brainer; flick 'em to "+4".
Again, welcome, and have fun!
MM
Mac 2012 12C Cheese Grater, OSX 10.13.6
MOTU DP8.07, MachFive 3.2.1, MIDI Express XT, 24I/O
Novation, Yamaha & Roland Synths, Guitar & Bass, Kemper Rack
Pretend I've placed your favourite quote here