MOTU TRAVELLER MK3 - I need help with internal connections

Moderator: James Steele

Forum rules
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. with Windows
Post Reply
cfors
Posts: 2
Joined: Tue Feb 14, 2017 3:08 am
Primary DAW OS: Windows

MOTU TRAVELLER MK3 - I need help with internal connections

Post by cfors »

I bought a MOTU MK3 TRAVELLER used and defective. The defect was not serious: two broken encoder which I replaced. But opening it I saw that someone had already tried to fix it and left detached the front panel connectors from the main board. Reconnecting the flat cable connectors, however, I saw that there is a single wire that starts from the front circuit with a female pin that will probably be connected to the male connector near the flat cable off the motherboard but do not know which male pin. To avoid doing harm anyone knows where it goes connected or has an Traveller MK3 interior photos where I can see well the connectors? Thank you in advance for your cooperation.
Post Reply