Hello...
On my Traveler (original, not mk3), the unit is sitting on a screen that says Motu Traveler Firmware Upgrade.
No inputs are working and my computer can't connect to it.
It was working, just fine, on Sunday.
Power-cycling the unit immediately displays Motu Traveler Firmware Upgrade.
I tried holding the Mix button (documented factory reset steps), but it won't change from that screen.
Any ideas?
This has been a solid interface for 9 years.
JJ
Won't Change From Motu Traveler Firmware Upgrade Screen
Moderator: James Steele
Forum rules
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. with Windows
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. with Windows
-
- Posts: 29
- Joined: Mon Jun 13, 2005 10:01 pm
- Primary DAW OS: Windows
- Location: Branson, MO
- Contact:
Re: Won't Change From Motu Traveler Firmware Upgrade Screen
I spoke with Motu's support and they said the ROM chip has failed.
I had posted, previously, about the Traveler forgetting routing http://www.motunation.com/forum/viewtop ... er#p481323.
They said that was indicative of an eventual failure.
I hope that helps someone.
JJ
I had posted, previously, about the Traveler forgetting routing http://www.motunation.com/forum/viewtop ... er#p481323.
They said that was indicative of an eventual failure.
I hope that helps someone.
JJ